RC-Hangout

Right, finally got round to working on my Fossil and a bind issue.

The issue i had was that i could not get my satellite to bind. Voltage from the 3v pin on the Naze was ok but could barely get a flicker of light on the Lemon satellite.
I had the red heron of two satellites being faulty, which i can only think i fried them?

So today i connected again and went through everything from the start:
1. Fresh model and TX set up.
2. Flash Naze to the latest version.
3. Set "spektrum_sat_bind=9".
4. Power up..........YES!!

BIND COMPLETE:)

Next issue:
Roll and Throttle are working together??

I have tried several combinations but cant get the reciever section to work correctly.

I am taking it with me tomorrow as i journey North to work, and will work on it this week:)

Suggestions as always appreciated:)

In the receiver tab have you set it to taer1234 (JR Spektrum)

KevG wrote:In the receiver tab have you set it to taer1234 (JR Spektrum)

Yes Kev.
Not come across this before. My gut feeling is it is a Naze problem, thats why i reflashed with latest version. There are even channels moving via the sticks for Aux 1,2,3?
If i was not 100% i would say the wiring on channel servo leads were plugged into the wrong channels but they are not???

Are you using pwm, ppm or serial?
Have you selected the correct one in the Naze?

You don't have some sort of mixing in the Tx?

Serial with satellite, no rx new model in tx no mixing

How about a capture of your config screen in the configurator.

Stambo wrote:How about a capture of your config screen in the configurator.

Iam 100 miles from home at work and guess what i left hanging in a bag in the hall:( DOH!!

Ok:) sorted the RX issue it was wrong setting in Spektrum 2048:)

Now the next problem, motors wont spin up and BLheli does not recognise the esc,s. This is the second time this has happened. Last time i had to reflash BLheli individually on Afro esc,s. Not sure if it is my laptop or something else?

What are the board LEDs doing?

Stambo wrote:What are the board LEDs doing?

This is really weird:( Cleanflight wont allow manually starting motors, BLheli doesn't recognize escs, but i armed it with TX and it spooled up??

I have 5 quads and never come across these issues before??

Well very confused?? Can get all functions working on Cleanflight, but cant get BLheli to work. Put Fossil together and did a test hover in the living room and it flew well??

Just the Volt and my 450 to get going and the Hanger is full again:)