Look whos ready to fly

Lee · Post by **Lee** » Sat Jun 27, 2015 9:46 am

After 6 months on the shelf, the 570 is ready to remaiden

Just need this stupid wind to calm down again.

: photo.JPG (281.68 KiB) Viewed 3985 times

cml001 · Post by **cml001** » Sat Jun 27, 2015 9:59 am

SCORE!

Derek · Post by **Derek** » Sat Jun 27, 2015 10:46 am

That's really cool, Lee! Glad you got it all back together and ready to go. Are those the Blackline blades?

Graham Lawrie · Post by **Graham Lawrie** » Sat Jun 27, 2015 12:46 pm

Great news Lee:)

KevG · Post by **KevG** » Sat Jun 27, 2015 12:54 pm

Great news mate, looking good!

treff · Post by **treff** » Sat Jun 27, 2015 2:30 pm

Yes, really good news Lee. Here almost rebuilt another Agile 5.5. Just waiting for funds to get some 6s batteries.

DOG · Post by **DOG** » Sat Jun 27, 2015 4:15 pm

Looking sweet!

Now go out and have some fun.

Lee · Post by **Lee** » Sat Jun 27, 2015 9:38 pm

Derek wrote:That's really cool, Lee! Glad you got it all back together and ready to go. Are those the Blackline blades?

Thanks guys.
Yes they are the Blackline 3Ds

Lee · Post by **Lee** » Sun Jun 28, 2015 8:42 pm

Umm, false start on the maiden.
Took it to the local club to test. Had forgotten to set up the tail limits.
Without my PC or my android phone, I was grounded

But now its all set up properly, and ready for tomorrow

Derek · Post by **Derek** » Sun Jun 28, 2015 9:12 pm

Sounds like a brain fart...we all have those. Good luck tomorrow Lee!

Lee · Post by **Lee** » Mon Jun 29, 2015 6:47 pm

Did my one full battery spool up on the ground today, to check for any issues before lift off.
Everything is still tight. Blade tracking was out, so a couple of turns of the turnbuckles, and its spot on.
Tomorrow I'll give it some air under its feet

Post by **pvolcko** » Mon Jun 29, 2015 6:59 pm

You check tracking on the ground? Interesting. I always lift off into a low hover and slowly move above and below my sight line to check the disc silhouette. I'm always worried about a tip over if I leave it on the ground too long.

Lee · Post by **Lee** » Mon Jun 29, 2015 7:03 pm

I normally lift off for tracking, but during the test spool up, it was really obvious the tracking was out.

Post by **pvolcko** » Mon Jun 29, 2015 9:17 pm

ah. Have had that happen. Can get a bit dicey trying to take off with it that bad.

Lee · Post by **Lee** » Wed Jul 01, 2015 2:06 pm

Maiden went really well.
Shes locked and loaded.
I'm sure you don't want to see me just hovering around in all orientations,
so i won't bother uploading the video, unless someone asks

Post by **pvolcko** » Wed Jul 01, 2015 2:43 pm

All orientations? 45degree quartering yaw on knife edge, skids in?

Lee · Post by **Lee** » Wed Jul 01, 2015 5:55 pm

Never seen a heli hover in a knife edge

Graham Lawrie · Post by **Graham Lawrie** » Wed Jul 01, 2015 6:39 pm

I want to see it

Derek · Post by **Derek** » Wed Jul 01, 2015 7:03 pm

Hovering with skids in? That would be impressive!

Tony · Post by **Tony** » Sat Jul 04, 2015 6:06 pm

Excellent news Lee, yeah I want to see the vid too, get it uploaded mate...

RC-Hangout

Look whos ready to fly

Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly

Re: Look whos ready to fly